KORG PA4X 76 - Manual (Page 519)

Effect parameters |515
a: Control Target
This parameter selects no level control, delay output control (effect bal-
ance), or feedback amount control.
a: Polarity
b: Threshold
b: Offset
c: Attack
d: Release
The “Offset” parameter specifies the value for the “Control Target” pa-
rameter (that is set to None), expressed as the ratio relative to the param-
eter value (the “Wet/Dry” value with “Control Target”=Output level, or the
“Feedback” value with “Control Target”=Feedback).
When “Polarity” is positive, the “Control Target” value is obtained by multi-
plying the parameter value by the “Offset” value (if the input level is below
the threshold), or equals the parameter value if the input level exceeds the
threshold.
When “Polarity” is negative, Control Target value equals the parameter val-
ue if the input level is below the threshold, or is obtained by multiplying the
parameter value by the “Offset” value if the level exceeds the threshold.
The “Attack” and “Release” parameters specify attack time and release time
of delay level control.
Dynamic Delay
Threshold
Dry
Envelope
Wet
Target=Output Level
Polarity= (–)
Wet
Target=Output Level
Polarity= (+)
Delay Time
Time
(Ducking Delay)
Release
Attack
Level