Lenze 9400 - Manual (Page 57)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
57
4 Drive interface
4.2 Device commands
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.2.13 Restart program
The C00002 = "35: Restart program" device command is used to restart the application program in
the controller.
• All variables except the RETAIN variables are reset to their initialisation value.
• The situation corresponds to a power failure or switching the controller off/on (warm start)
while the program is running.
Possible status displays for this device command
Related device commands
 Reset program ( 55)
 Delete program ( 56)
Status ( C00003 ) Meaning
2327810 Device command in process
2293760 Device command executed successfully
2293761 General fault