Lenze 9400 - Manual (Page 657)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
657
13 Diagnostics & fault analysis
13.7 Error messages of the operating system
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Failure of motor phase W [0x007b002f]
Electronic nameplate: Data loaded [0x007b0030]
Electronic nameplate: Not found [0x007b0031]
Electronic nameplate: Encoder protocol unknown [0x007b0032]
Electronic nameplate: Encoder signal unknown [0x007b0033]
Module ID (decimal) Error ID (decimal)
123: Motor control 47
Response (Lenze setting printed in bold) Setting: C00597 ( Adjustable response)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
W phase interruption of the motor cable. • Check cabling between the controller and motor.
• Check parameter setting ( C00599 ).
Module ID (decimal) Error ID (decimal)
123: Motor control 48
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
New electronic nameplate (ENP) has been found. - (Information only)
Module ID (decimal) Error ID (decimal)
123: Motor control 49
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Electronic nameplate (ENP) is not available. - (Information only)
Module ID (decimal) Error ID (decimal)
123: Motor control 50
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The connected motor with feedback is not supported by
the controller firmware.
Check drive dimensioning.
Module ID (decimal) Error ID (decimal)
123: Motor control 51
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The connected motor with feedback is not supported by
the controller firmware.
Check drive dimensioning.