Lenze 9400 - Manual (Page 659)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
659
13 Diagnostics & fault analysis
13.7 Error messages of the operating system
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Electronic nameplate: Data outside the parameter limits [0x007b0039]
Hiperface encoder: Transmission error [0x007b003a]
Hiperface encoder: Command error [0x007b003b]
Module ID (decimal) Error ID (decimal)
123: Motor control 57
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The motor parameters of the electronic nameplate are
outside of the limit values of the controller and therefore
cannot be accepted.
Consultation with Lenze required.
Module ID (decimal) Error ID (decimal)
123: Motor control 58
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
• Encoder signal interferences (EMC).
• Encoder cable interrupted.
• Encoder defective.
• Faulty parameter setting of the encoder.
Note: This information is always supplied together with
the "I/O error - encoder communication" error message
and is entered in the logbook even if the encoder
monitoring is deactivated ( C00580 ).
• Check encoder cable, use shorter encoder cable if
required.
• Check encoder.
• Check parameter setting ( C00420 , C00421 , C00422 ).
Module ID (decimal) Error ID (decimal)
123: Motor control 59
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
• Encoder signal interferences (EMC).
• Encoder cable interrupted.
• Encoder defective.
• Faulty parameter setting of the encoder.
Note: This information is always supplied together with
the "I/O error - encoder communication" error message
and is entered in the logbook even if the encoder
monitoring is deactivated ( C00580 ).
• Check encoder cable, use shorter encoder cable if
required.
• Check encoder.
• Check parameter setting ( C00420 , C00421 , C00422 ).