Lenze 9400 - Manual (Page 708)

13 Diagnostics & fault analysis
13.7 Error messages of the operating system
708
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Int. overflow C02708/2 (decel. limited speed 2) [0x00b80029]
Int. overflow C02708/3 (decel.limited speed 3) [0x00b8002a]
Int. overflow C02708/4 (decel. limited speed 4) [0x00b8002b]
Module ID (decimal) Error ID (decimal)
184: Basic drive functions 41
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
From software version V3.0
Due to a subsequent change of the machine parameters
for gearbox ratio, feed constant, or resolution of an
encoder revolution, the value set in the parameter
cannot be displayed in the internal unit. See chapter
" Max. position, speed, and acceleration that can be
displayed internally ".
• Check machine parameters and adapt them if
required.
• Change setting in C02710/2 .
Module ID (decimal) Error ID (decimal)
184: Basic drive functions 42
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
From software version V3.0
Due to a subsequent change of the machine parameters
for gearbox ratio, feed constant, or resolution of an
encoder revolution, the value set in the parameter
cannot be displayed in the internal unit. See chapter
" Max. position, speed, and acceleration that can be
displayed internally ".
• Check machine parameters and adapt them if
required.
• Change setting in C02710/3 .
Module ID (decimal) Error ID (decimal)
184: Basic drive functions 43
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
From software version V3.0
Due to a subsequent change of the machine parameters
for gearbox ratio, feed constant, or resolution of an
encoder revolution, the value set in the parameter
cannot be displayed in the internal unit. See chapter
" Max. position, speed, and acceleration that can be
displayed internally ".
• Check machine parameters and adapt them if
required.
• Change setting in C02710/4 .