Hyundai HI4 - Manual (Page 180)

6. System setting
------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------
6 - 16
6.2.1.2 Output signal Logic
Outline
It sets up the positive, negative logic of the general output signal.
Screen display
Selection Method
① The user moves the cursor to the position where the user wants to change.
You can use "Previous [PF3]", "Next [PF4]" if there is no signal as you want to change
in the present screen.
② You change the signal logic with using [Shift]+[← ][→ ]Key.
Reference
„ You must always press the "Complete [PF5]"Key to store the changing content after
finishing the change of output signal logic.
14:39:38*** DO signal logic *** A:0 S:4
DO1 = < Posi ,Nega> DO2 = < Posi ,Nega>
DO3 = < Posi ,Nega> DO4 = < Posi ,Nega>
DO5 = < Posi ,Nega> DO6 = < Posi ,Nega>
DO7 = < Posi ,Nega> DO8 = < Posi ,Nega>
DO9 = < Posi ,Nega> DO10 = < Posi ,Nega>
DO11 = < Posi ,Nega> DO12 = < Posi ,Nega>
DO13 = < Posi ,Nega> DO14 = < Posi ,Nega>
DO15 = < Posi ,Nega> DO16 = < Posi ,Nega>
DO17 = < Posi ,Nega> DO18 = < Posi ,Nega>
DO19 = < Posi ,Nega> DO20 = < Posi ,Nega>
Press [SHIFT]+[<-][->] Key
>
Previous Next