Hyundai HI4 - Manual (Page 247)

6. System setting
------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------
6 - 83
6.4.2 Arc
Outline
It sets a function to do the arc welding.
Please refer to the "Operation manual on the HR controller" for the precise contents.
Screen display
Reference
„ The arc condition parameter is taken in custody in the control constant file
(ROBOT.C00).
„ It can be changed in case that the control constant file (ROBOT.C00) is completely
taken in custody.
6.4.2.1 Condition parameter
Outline
It sets a variety of condition for the welding work in the arc welding.
Screen display
14:39:38 *** Arc Weld *** A:0 S:4
1: Condition Parameter
Use [Number]/[Up][Down] and press [SET].
>
Previous Next
14:39:38 ** Arc Weld ** A:0 S:4
1: Fast step Go/Back = Max.speed*[ 1 ]%
2: Inching Spd: Slow=[ 1]%,Fast=[ 1]%
3: Assign Welding Current Port =[ 0]
4: Assign Welding Voltage Port =[ 0]
5: Assign [ARC On] state output =[ 0]
6: Welder error input =<
DSBL ,ENBL>
7: Welding wire state =< DSBL ,ENBL>
8: Shield Gas state =< DSBL ,ENBL>
9: Feeder Ty=(Motor & Dir.)=< DSBL ,ENBL>
10: Gas Postflow at weld stop =[ 0.0]sec
Enter number and press [SET]
>[1 - 25]