Hyundai HI4 User Manual
Page 303
7. R code
------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------
7 - 27
7.24 (24) R204 SPOT WELDING CONDITION MANUAL OUTPUT
Outline
It outputs spot welding condition manually.
Operation method
In case of < Welding condition output type = Discrete >, at "System"[PF2] -> 4.
Application Parameter -> Spot & Stud -> 1.Welding Parameter. It will be appeared on
the screen as following message.
In case of < Welding condition output type = Binary code > at "System"[PF2] -> 4.
Application Parameter -> Spot & Stud -> 1.Welding Parameter. It will be appeared on
the screen as following message.
After inputting the welding condition with numeric key, press [SET] key.
Reference
⑴ It cannot be executed during operation.
Input discrete welding condition (0 - 7)
>R204,
Service
System
Rel.WAIT
Cond Set
Input binary WELDg condition ( 0 - 255 )
>R204,
Service
System
Rel.WAIT
Cond Set