4 configuring telnet, 1 show telnet, Configuring telnet -54 3.2.4.1 – Enterasys Networks 1G58x-09 User Manual
Page 102: Show telnet -54, Section 3.2.4, Commands
General Configuration Command Set
Configuring Telnet
3-54
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
3.2.4
Configuring Telnet
To review, enable, disable and configure Telnet services to the device when operating in switch
mode.
Commands
The commands needed to configure Telnet are listed below and described in the associated section
as shown.
•
show telnet (
)
•
set telnet (
)
3.2.4.1
show telnet
Use this command to display Telnet status and information.
show telnet
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-only.
Example
This example shows how to display Telnet status and information. In this case inbound and
outbound service is enabled on the device and maximum number of inbound, outbound and SSH