2 set pwa, Set pwa -67, Section 14.3.5.2 – Enterasys Networks 1G58x-09 User Manual
Page 749
Security Configuration Command Set
Configuring Port Web Authentication (PWA)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
14-67
14.3.5.2 set pwa
Use this command to enable or disable port web authentication.
set pwa {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable port web authentication:
Quiet Period
Amount of time a port will be in the held state after a user
unsuccessfully attempts to log on to the network. Default
value of 60 can be changed using the set pwa quietperiod
command as described in
.
MaxReq
Maximum number of log on attempts allowed before
transitioning the port to a held state. Default value of 2 can
be changed using the set pwa maxrequests command as
described in
NOTE: Port Web Authentication cannot be enabled if either MAC authentication or
EAPOL (802.1X) is enabled. For information on disabling 802.1X, refer to
. For information on disabling MAC authentication, refer to
enable | disable
Enables or disables port web authentication.
Matrix>set pwa enable
Table 14-7
show pwa Output Details (Continued)
Output
What It Displays...