Enterasys Networks 1G58x-09 - Manual (Page 259)

SNMP Command Set
Configuring SNMP Target Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 5-37
5.2.5 Configuring SNMP Target Parameters
Purpose
To review and configure SNMP target parameters. This controls where and under what
circumstances SNMP notifications will be sent. A target parameter entry can be bound to a target
IP address allowed to receive SNMP notification messages with the set snmp targetaddr
command (
Section 5.2.6.2 ).
Commands
The commands needed to review and configure SNMP target parameters are listed below and
described in the associated section as shown.
• show snmp targetparams ( Section 5.2.5.1 )
• set snmp targetparams ( Section 5.2.5.2 )
• clear snmp targetparams ( Section 5.2.5.3 )
5.2.5.1 show snmp targetparams
Use this command to display SNMP parameters used to generate a message to a target.
show snmp targetparams [targetparams]
Syntax Description
Command Defaults
If targetParams is not specified, entries associated with all target parameters will
be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
targetparams (Optional) Displays entries for a specific target
parameter.