Enterasys Networks 1G58x-09 - Manual (Page 412)

Policy Classification Configuration Command Set
Assigning Classification Rules to Policy Profiles
8-20 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
8.3.2.8 set policy maptable response
Use this command to select which RADIUS attributes to use if both tunnel attributes and a profile
filter ID are present. If only one attribute is present, it will be used regardless of this setting. If
vlantunnel is selected, the VLAN tunnel attributes will take priority over the profile filter ID, even
if the vlanauthorization table is disabled (as described in
Section 8.3.2.7 ). If a port is authenticated
to a VLAN, the port VLAN is overridden and, if present, any default policy on the port will be
removed.
set policy maptable response {policyprofile | vlantunnel}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to configure policy authentication to use VLAN tunnel attributes:
8.3.2.9 clear policy maptable response
Use this command to clear the policy map table response configuration.
clear policy maptable response
Syntax Description
None.
Command Defaults
None.
policyprofile |
vlantunnel Configures policy authentication to use the profile filter
ID or VLAN tunnel attributes.
Matrix>set policy maptable response vlantunnel