Enterasys Networks 1G58x-09 - Manual (Page 170)

Port Configuration Command Set
Setting Port Auto-Negotiation and Advertised Ability
4-24 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
This command shows the verbose display of advertised ability for port fe.0.1 :
Table 4-4 provides an explanation of the verbose command output.
Matrix>show port advertised ability fe.0.1 verbose
fe.0.1 Capability Advertised Remote
----------------------------------------------------------
BASE10-T yes yes yes
BASE10-TFD yes yes no
BASE100-TX yes yes no
BASE100-TXFD yes yes no
BASE1000-X no no no
BASE1000-XFD no no no
BASE1000-T no no no
BASE1000-TFD no no no
pause yes yes no
Table 4-4 VerboseOutput Details
Output What It Displays...
Capability Whether or not the port is capable of operating in the
following modes:
• BASE10-T - 10BASE-T half duplex mode
• BASE10-TFD - 10BASE-T full duplex mode
• BASE100-TX - 100BASE-TX half duplex mode
• BASE100-TXFD - 100BASE-TX full duplex mode
• BASE1000-X - 1000BASE-X, -LX, -SX, -CX half
duplex mode
• BASE1000-XFD - 1000BASE-X, -LX, -SX, -CX full
duplex mode
• BASE1000-T - 1000BASE-T half duplex mode
• BASE1000-TFD - 1000BASE-T full duplex mode
• pause - PAUSE for full-duplex links
Advertised Whether or not the port is configured to advertise it is
capable of operating in the modes listed.
Remote Whether this port’s link partner is advertising the listed
mode.
On fiber ports, the switch is unable to get the remote
information, so "---" is displayed instead of "yes" or "no."