Enterasys Networks 1G58x-09 - Manual (Page 626)

Process Overview: Routing Protocol Configuration
Configuring OSPF
13-32 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command resets the value to the default of 1:
no ip ospf priority
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan <vlan_id>))#
Command Defaults
None.
Example
This example shows how to set the OSPF priority to 20 for VLAN 1:
13.1.2.6 timers spf
Use this command to change OSPF timer values to fine-tune the OSPF network.
timers spf spf-delay spf-hold
number Specifies the router’s OSPF priority in a range from 0 to
255.
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip ospf priority 20