Enterasys Networks 1G58x-09 - Manual (Page 791)

Security Configuration Command Set
Configuring Flow Setup Throttling (FST)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 14-109
14.3.9.5 clear flowlimit action
Use this command to remove an existing flow limit action.
clear flowlimit action {1 | 2}{aggregationport | interswitchlink | serverport |
unspecified | userport} {discard | drop | trap | disable}}
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
None.
Example
This example shows how to remove flow limiting action 1, which is to discard all flows exceeding
12 on ports classified as user ports:
1 | 2 Specifies that action 1 or 2 will be removed.
aggregationport |
interswitchlink |
serverport |
unspecified |
userport Removes this action configuration from the specified user
classification port type. For a description of these
parameters, refer back to
Section 14.3.9.3 .
limit Specifies the number of flows that will trigger this action
configuration. Valid values are 0 - 128000.
discard | drop |
trap | disable Specifies the action to be removed. For a description of
these parameters, refer back to
Section 14.3.9.3
Matrix>clear flowlimit action 1 userport 12 discard