Enterasys Networks 1G58x-09 - Manual (Page 547)

Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-77
Example
This example shows how to globally enable CEP detection :
11.2.6.3 set cep port
Use this command to enable or disable a CEP detection type on one or more ports.
set cep port port-string {cisco | h323 | siemens} {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable Cisco phone detection on port fe. 3. 1 :
11.2.6.4 set cep policy
Use this command to set a global default policy for a CEP detection type. This is the policy that will
be applied when a phone of the specified type is detected on a port. It must be configured using the
policy management commands described in
Chapter 11 .
set cep policy {cisco | h323 | siemens} profile-id
Matrix>set cep enable
port-string Specifies the port(s) to enable or disable. For a detailed
description of possible port-string values, refer to
Section 4.1.2 .
cisco | h323 |
siemens Specifies the CEP detection that will be applied as Cisco,
H.323 or Siemens phone detection.
enable | disable Enables or disables CEP detection as specified.
Matrix>set cep port fe.3.1 cisco enable