Enterasys Networks 1G58x-09 User Manual
Page 789
Security Configuration Command Set
Configuring Flow Setup Throttling (FST)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
14-107
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
None.
Example
This example shows how to set flow limiting
action 1 to discard all flows exceeding 12 on ports
classified as user ports:
discard | drop |
trap | disable
Specifies the action to be taken if flow limit is reached as:
•
Discarding excess flows. This causes a “discard flow” to
be created. Packets are accepted to this flow but are
discarded (not forwarded anywhere). This allows the
flow counters to be updated (and possibly reach a second
higher threshold action (for example: trap or disable, as
described below).
•
Dropping excess flows. The E1 does not support this
option. If set, the E1 will behave the same as setting the
attribute to “discard” and discard flows will be created.
•
Generating an SNMP trap notification (if the set
flowlimit notification function is enabled as described
in
).
•
Disabling the interface (if the set flowlimit shutdown
function is enabled as described in
).
This will clear all FST settings on the port.
Matrix>set flowlimit limit 1 userport 12 discard