Enterasys Networks 1G58x-09 - Manual (Page 687)

Security Configuration Command Set
Configuring RADIUS
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 14-5
Example
This example shows how to display RADIUS configuration information:
Table 14-1 provides an explanation of the command output.
Matrix>show radius
RADIUS status: Disabled
RADIUS retries: 3
RADIUS timeout: 20 seconds
RADIUS mgmt-auth status: Disabled
Server Server
Index IP Auth-Port Status
---------------------------------------------------
100 1.2.100.2 1812 Primary
RADIUS last-resort-action Status
------------------------- ------
Local Challenge
Remote Challenge
Table 14-1 show radius Output Details
Output What It Displays...
RADIUS status Whether RADIUS is enabled or disabled.
RADIUS retries Maximum number of attempts a user can contact the
RADIUS server before timing out. The default value of 3
can be reset using the set radius command as described in
Section 14.3.1.2 .
RADIUS timeout Maximum amount of time (in seconds) to establish contact
with the RADIUS server before timing out. The default
value of 20 can be reset using the set radius command as
described in
Section 14.3.1.2 .
RADIUS
mgmt-auth status Whether RADIUS login authentication is enabled or
disabled on management sessions. Default state of enabled
can be changed using the set radius command as described
in
Section 14.3.1.2 .
Server Index Index assigned to the RADIUS server. The Matrix E1 Series
device allows for up to 10 RADIUS servers to be
configured, with up to 2 active at any given time.