Enterasys Networks 1G58x-09 - Manual (Page 120)

General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
3-72 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
This example shows how to disable Enterasys Discovery Protocol for Fast Ethernet expansion
module 2, port 1:
3.2.6.3 set cdp interval
Use this command to set the message interval frequency of the Enterasys Discovery Protocol.
set cdp interval frequency
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the CDP interval frequency to 15 seconds:
3.2.6.4 show ciscodp
Use this command to display global Cisco Discovery Protocol information.
show ciscodp
Syntax Description
None.
Command Defaults
None.
Matrix>set cdp disable fe.2.1
frequency Specifies the transmit frequency of Enterasys Discovery
Protocol messages in seconds.Valid values are from 5 to
900.
Matrix>set cdp interval 15