Enterasys Networks 1G58x-09 - Manual (Page 427)

Port Priority and Classification Configuration Commands
Configuring Priority to Transmit Queue Mapping
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 9-9
9.3.2.2 set priority queue
Use this command to map 802.1p priorities to transmit queues. This enables you to change the
priority queue (0 -3, with 0 being the lowest priority queue) for each port priority of the selected
port. You can apply the new settings to one or more ports.
For example, if the priority queue is set to 3 for those frames with a port priority 7, then those frames
would be transmitted before any frames contained in traffic classes 2 through 0.
Refer to the following table for the transmit priority queue default values according to port priority.
set priority queue priority queue
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Frame Port
Priority
0 1 2 3 4 5 6 7
Transmit Port
Priority Queue
(Traffic Class) 1 0 0 1 2 2 3 3
priority Specifies a value of 0 - 7 (0 is the lowest level) that
determines what priority frames will be transmitted at the
priority queue level (0 - 3) entered in this command.
queue Specifies a value of 0 - 3 (0 is the lowest level) that
determines when to transmit the frames with the port
priority entered in this command.