Enterasys Networks 1G58x-09 - Manual (Page 397)

Policy Classification Configuration Command Set
Configuring Policy Profiles
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 8-5
Example
This example shows how to enable policy profile 1 named netadmin. VLAN classification is
enabled for this policy on VLAN 1 and Class of Service classification is disabled for class 0:
8.3.1.3 clear policy profile
Use this command to delete one or all policy profile entries.
clear policy profile profile-index | all
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to delete policy profile 8:
8.3.1.4 show policy invalid action
Displays information about the action the device will apply on an invalid or unknown policy, and,
if applicable, the invalid policy ID that was attempted during authentication.
show policy invalid action
Syntax Description
None.
Matrix>set policy profile 1 enable netadmin enable 1 disable 0
profile-index Specifies the index number of the profile entry to be
deleted. Valid values are 1 to 65535.
all Deletes all policy profile entries.
Matrix>clear policy profile 8