Enterasys Networks 1G58x-09 - Manual (Page 776)

Security Configuration Command Set
Configuring Access Lists
14-94 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
protocol Specifies an IP protocol for which to deny or permit access.
Valid values and their corresponding protocols are:
• ip - Any Internet protocol
• icmp - Internet Control Message Protocol
• udp - User Datagram Protocol
• tcp - Transmission Protocol
source Specifies the network or host from which the packet will be
sent. Valid options for expressing source are:
• IP address or range of addresses (A.B.C.D)
• any - Any source host
• host source - IP address of a single source host
source-wildcard (Optional) Specifies the bits to ignore in the source address.
destination Specifies the network or host to which the packet will be
sent. Valid options for expressing destination are:
• IP address (A.B.C.D)
• any - Any destination host
• host source - IP address of a single destination host
destination-
wildcard (Optional) Specifies the bits to ignore in the destination
address.
icmp-type (Optional) Filters ICMP frames by ICMP message type. The
type is a number from 0 to 255.
icmp-code (Optional) Further filters ICMP frames filtered by ICMP
message type by their ICMP message code. The code is a
number from 0 to 255.