Enterasys Networks 1G58x-09 - Manual (Page 86)

General Configuration Command Set
Setting Basic Device Properties
3-38 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
3.2.2.10 set system name
Use this command to configure a name for the system.
set system name [“name_string”]
Syntax Description
Command Defaults
If name_string is not specified, the system name will be set to a blank string.
Command Type
Switch command.
Command Mode
Read-Write.
Usage Guidelines
None.
Table 3-5 show version Output Details
Output What It Displays...
Slot Fixed front panel or expansion module slot location
designation. For details on how slots are numbered, refer to
Section 4.1.2 .
Ports Number of ports in the fixed front panel or expansion
module.
Model Model number of the chassis or expansion module.
Serial Number Serial number (if applicable) of the chassis or expansion
module.
HW Version Hardware version number (if applicable) of the chassis or
expansion module.
FW Version Current firmware version number (if applicable).
name_string (Optional) Specifies a text string that identifies the system.
A name string containing a space in the text must be
enclosed in quotes as shown in the example below.