Enterasys Networks 1G58x-09 - Manual (Page 435)

Port Priority and Classification Configuration Commands
Configuring Priority Classification
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 9-17
9.3.4.1 show priority classification
Use this command to display priority classification information.
show priority classification
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Command Alternative (v2.05.xx and higher)
show policy class ( Section 8.3.2.1 )
Example
This example shows that priority classification is currently enabled on the device and that two
priority classification entries have been created with a priority of 5. Currently, there are no ports on
the priority classification ingress list associated with these classification rules. The
ingress list is
created using the set priority classification ingress command described in Section 9.3.5.1 .
Matrix>show priority classification
Priority Classification enabled.
Priority Classification Entries
--------------------------------
Priority: 5, Ethernet II Type: IP, Status: enabled,
Tos Value: 0, Tos Status: disabled,
Port List: None
----------
Priority: 5, Src UDP Range: 44-46, Status: enabled,
Tos Value: 0, Tos Status: disabled,
Port List: None