Enterasys Networks 1G58x-09 - Manual (Page 604)

Process Overview: Routing Protocol Configuration
Configuring RIP
13-10 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Defaults
None.
Example
This example shows how to set the RIP send version to 2 for packets transmitted on VLAN 1:
13.1.1.8 ip rip receive version
Use this command to set the RIP version(s) for update packets accepted on the interface.
ip rip receive version {1 | 2 | 1 2 | none}
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command restores the default version of the RIP update
packets that are accepted on the interface:
no ip rip receive version
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan <vlan_id>))#
Command Defaults
None.
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip rip send version 2
1 Specifies RIP version 1.
2 Specifies RIP version 2.
12 Specifies both versions 1 and 2.
none Specifies that no RIP routes will be processed on this
interface.