Enterasys Networks 1G58x-09 - Manual (Page 88)

General Configuration Command Set
Setting Basic Device Properties
3-40 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
3.2.2.12 set system contact
Use this command to identify a contact person for the system.
set system contact [“contact_string”]
Syntax Description
Command Defaults
If contact_string is not specified, the contact name will be set to a blank string.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the system contact string:
3.2.2.13 show terminal
Use this command to display the number of columns and rows for the terminal connected to the
device’s console port. This information is used to control the output of the CLI itself.
show terminal
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
contact_string (Optional) Specifies a text string that contains the name
of the person to contact for system administration. A
contact string containing a space in the text must be
enclosed in quotes as shown in the example below.
Matrix>set system contact “Joe Smith”