Enterasys Networks 1G58x-09 - Manual (Page 597)

Process Overview: Routing Protocol Configuration
Configuring RIP
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 13-3
13.1.1.1 router rip
Use this command to enable or disable RIP configuration mode.
router rip
Configure RIP authentication. key chain ( Section 13.1.1.9 )
key ( Section 13.1.1.10 )
key-string ( Section 13.1.1.11 )
accept-lifetime ( Section 13.1.1.12 )
send-lifetime ( Section 13.1.1.13 )
ip rip authentication keychain ( Section 13.1.1.14 )
ip rip authentication mode ( Section 13.1.1.15 )
Disable automatic route summarization
(necessary for enabling CIDR) no auto-summary ( Section 13.1.1.16 )
Disable triggered updates. ip rip disable-triggered-updates ( Section 13.1.1.17 )
Disable or re-enable split horizon. ip split-horizon ( Section 13.1.1.18 )
Control the processing of routing updates. passive-interface ( Section 13.1.1.19 )
receive interface ( Section 13.1.1.20 )
distribute-list ( Section 13.1.1.21 )
Enable redistribution from non-RIP
routes. redistribute ( Section 13.1.1.22 )
NOTE: You must execute the router rip command to enable the protocol before
completing many RIP-specific configuration tasks. For details on enabling configuration
modes, refer to
Table 3-10 in Section 3.3.3 .
Table 13-1 RIP Configuration Task List and Commands (Continued)
To do this... Use these commands...