Enterasys Networks 1G58x-09 - Manual (Page 334)

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Port Parameters
6-48 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the span guard function status:
6.2.2.15 set spantree spanguard
Use this command to enable or disable the Spanning Tree span guard function. When enabled, this
prevents an unauthorized bridge from becoming part of the active Spanning Tree topology. It does
this by disabling a port that receives a BPDU when that port has been defined as an edge (user) port
(as described in
Section 6.2.2.12 ). This port will remain disabled until the amount of time defined
by the set spantree spanguardtimeout ( Section 6.2.2.18 ) has passed since the last seen BPDU or
the port is manually unlocked (as described in Section 6.2.2.21 ).
set spantree spanguard {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Matrix>show spantree spanguard
spanguard is currently disabled.
enable | disable Enables or disables the span guard function.