2 setting basic device properties, Setting basic device properties -30, Section 3.2.2 – Enterasys Networks 1G58x-09 User Manual
Page 78: 2 setting basic device properties purpose, Commands
General Configuration Command Set
Setting Basic Device Properties
3-30
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
3.2.2
Setting Basic Device Properties
Purpose
To display and set the basic system (device) information, including password, system time, system
prompt, contact name, terminal output, lockout time, timeout, console baud rate and version
information, to display or set the system IP address, and to download a new firmware image to the
device.
Commands
The commands needed to set basic system information are listed below and described in the
associated section as shown.
•
show system resources (
)
•
•
)
•
set prompt (
)
•
show banner motd (
)
•
set banner motd (
•
clear banner motd (
•
show version (
)
•
)
•
•
)
•
•
set terminal (
•
set system timeout (
•
set console baud (
•
show ip address (
•
set ip address (
)