Enterasys Networks 1G58x-09 - Manual (Page 281)

SNMP Command Set
Configuring SNMP Notification Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 5-59
Command Mode
Read-Write.
Example
This example shows how to delete the SNMP notify filter “pilot1”:
5.2.7.12 show snmp notifyprofile
Use this command to display SNMP notify profile information. This associates target parameters to
an SNMP notify filter to determine who should not receive SNMP notifications.
show snmp notifyprofile [profile] [targetparam targetparam]
Syntax Description
Command Defaults
If no parameters are specified, all notify profile information will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display SNMP notify information for the profile named “area51”:
Matrix>clear snmp notifyfilter pilot1 subtree 1.3.6
profile (Optional) Displays a specific notify profile.
targetparam
targetparam (Optional) Displays entries for a specific target
parameter.
Matrix>show snmp notifyprofile area51
--- SNMP notifyProfile information ---
Notify Profile = area51
TargetParam = v3ExampleParams
Storage type = nonVolatile
Row status = active