Enterasys Networks 1G58x-09 - Manual (Page 627)

Process Overview: Routing Protocol Configuration
Configuring OSPF
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 13-33
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command restores the default timer values (5 seconds for
delay and 10 seconds for holdtime):
no timers spf
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router(config-router)#
Command Defaults
None.
Example
This example shows how to set spf delay time to 7 seconds and hold time to 3:
13.1.2.7 ip ospf retransmit-interval
Use this command to set the amount of time between retransmissions of link state advertisements
(LSAs) for adjacencies that belong to an interface.
ip ospf retransmit-interval seconds
spf-delay Specifies the delay, in seconds, between the receipt of an
update and the SPF execution. Valid values are 0 to
4294967295.
spf-hold Specifies the minimum amount of time, in seconds, between
two consecutive OSPF calculations. Valid values are 0 to
4294967295. A value of 0 means that two consecutive OSPF
calculations are performed one immediately after the other.
Matrix>Router(config)#ospf 1
Matrix>Router(config-router)#timers spf 7 3