Enterasys Networks 1G58x-09 - Manual (Page 142)

Preparing the Device for Router Mode
Configuring VLANs for IP Routing
3-94 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
The example in Figure 3-7 shows how to configure two VLANs for IP routing. VLAN 10 is set on
Fast Ethernet front panel port 1 with an IP address of 182.127.63.1, and VLAN 20 is set on Fast
Ethernet front panel port 2 with an IP address of 182.127.62.1. The configuration is then saved to
NVRAM in file called startup.cfg.
Step 4 Disable GVRP on
the dedicated routing
port. set gvrp disable
port-string Switch:
(Matrix>) Section 7.3.8.3
Step 5 Repeat steps 1 through 4 to create additional VLAN(s).
Step 6 Enable router mode. router Switch:
(Matrix>) Section 3.3.3
Step 7 Enable global router
configuration mode. configure
terminal Router:
Matrix>Router# Section 3.3.3
Step 8 Enable interface
configuration mode. interface vlan_id Router:
Matrix>
Router(config)# Section 12.2.1.2
Step 9 Assign an IP address
to the VLAN. ip address
{ip_address
ip_mask} Router:
Matrix>
Router(config-if
(Vlan
<vlan_id>))# Section 12.2.1.4
Step 10 Enable the VLAN
for IP routing. no shutdown Router:
Matrix>
Router(config-if
(Vlan 1))# Section 12.2.1.5
Step 11 Repeat steps 6 through 10 to configure additional VLAN(s) for IP routing.
Step 12 Save the routing
configuration to
NVRAM. write file
filename
config_file Router:
Matrix>Router# Section 12.2.2.2
Table 3-9 Command Set for Configuring VLANs for IP Routing (Continued)
To do this task...
Type this
command...
In this mode...
For details,
see...