Enterasys Networks 1G58x-09 - Manual (Page 583)

IP Configuration Command Set
Reviewing IP Traffic and Configuring Routes
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 12-27
12.2.5 Reviewing IP Traffic and Configuring Routes
Purpose
To review IP protocol information about the device, to review IP traffic and configure routes, to
enable and send router ICMP (ping) messages, and execute traceroute.
Commands
The commands needed to review IP traffic and configure routes are listed below and described in
the associated section as shown:
• show ip protocols ( Section 12.2.5.1 )
• show limits ( Section 12.2.5.2 )
• show ip traffic ( Section 12.2.5.3 )
• clear ip stats ( Section 12.2.5.4 )
• show ip route ( Section 12.2.5.5 )
• ip route ( Section 12.2.5.6 )
• ip icmp ( Section 12.2.5.7 )
• ping ( Section 12.2.5.8 )
• traceroute ( Section 12.2.5.9 )
12.2.5.1 show ip protocols
Use this command to display information about IP protocols running on the device.
show ip protocols
Syntax Description
None.
Command Type
Router command.
Command Mode
Privileged EXEC: Matrix>Router#
Command Defaults
None.