Enterasys Networks 1G58x-09 - Manual (Page 570)

IP Configuration Command Set
Reviewing and Configuring the ARP Table
12-14 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
12.2.3 Reviewing and Configuring the ARP Table
Purpose
To review and configure the routing ARP table, to enable proxy ARP on an interface, and to set a
MAC address on an interface.
Commands
The commands needed to review and configure the ARP table are listed below and described in the
associated section as shown:
• show ip arp ( Section 12.2.3.1 )
• arp ( Section 12.2.3.2 )
• ip gratuitous-arp-learning ( Section 12.2.3.3 )
• ip proxy-arp ( Section 12.2.3.4 )
• ip mac-address ( Section 12.2.3.5 )
• arp timeout ( Section 12.2.3.6 )
• clear arp-cache ( Section 12.2.3.7 )
12.2.3.1 show ip arp
Use this command to display entries in the ARP (Address Resolution Protocol) table. ARP converts
an IP address into a physical address.
show ip arp [ip_address] [vlan vlan_id] [output-modifier]