Enterasys Networks 1G58x-09 - Manual (Page 673)

Process Overview: Routing Protocol Configuration
Configuring VRRP
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 13-79
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command clears the VRRP address configuration:
no address vlan vlan_id vrid ip_address owner
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router(config-router)#
Command Defaults
None.
Example
This example shows how to configure a virtual router address of 182.127.62.1 on VLAN 1, VRID
1, and to set the router connected to the VLAN via this interface as the master:
13.1.5.4 priority
Use this command to set a priority value for a VRRP router.
priority vlan vlan_id vrid priority_value
vlan vlan_id Specifies the number of the VLAN on which to configure a
virtual router address. This VLAN must be configured for IP
routing as described in
Section 3.3.2 .
vrid Specifies a unique Virtual Router ID (VRID) associated
with the routing interface. Valid values are from 1 to 255.
ip_address Specifies the virtual router IP address to associate with the
router.
owner Specifies a value to indicate if the router owns the IP
address as one of its interfaces. Valid values are:
• 1 to indicate the router owns the address.
• 0 to indicate the router does not own the address.
Matrix>Router(config)#router vrrp
Matrix>Router(config-router)#address vlan 1 1 182.127.62.1 1