Enterasys Networks 1G58x-09 - Manual (Page 367)

VLAN Configuration Command Set
Assigning VLANs According to Classification Rules
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 7-25
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Command Alternative (v2.05.xx and higher)
show policy class ( Section 8.3.2.1 )
Example
This example shows that the VLAN classification function is enabled, and that two VLAN
classifications have been configured on the device:
7.3.5.2 set vlan classification
Use this command to
• assign or contain frames according to classification rule,
• enable or disable the global classifier on the device,
• create a rule that will assign untagged traffic to a VLAN based on Layer 2/3/4 classification
rules, and
• enable or disable a classification rule associated with a VLAN.
Matrix>show vlan classification
VLAN Classification enabled.
Vlan Classification Entries
--------------------------------
Vlan ID: 5, Src UDP Range: 45-53, Status: enabled,
Action Status: Forward No Frames
Port List: None
----------
Vlan ID: 7, Ethernet II Type: IP, Status: enabled,
Action Status: Forward All Frames
Port List: None