Enterasys Networks 1G58x-09 - Manual (Page 320)

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
6-34 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
6.2.1.38 clear spantree txholdcount
Use this command to reset the transmit hold count to the default value of 3.
clear spantree txholdcount
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the transmit hold count to 3:
6.2.1.39 set spantree maxhops
Use this command to set the Spanning Tree maximum hop count. This is the maximum number of
hops that the information for a particular Spanning Tree instance may traverse (via relay of
BPDUs within the applicable MST region) before being discarded.
set spantree maxhops max_hop_count
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Matrix>clear spantree txholdcount
max_hop_count Specifies the maximum number of hops allowed. Valid
values are 0 to 255. Default value is 20.