Enterasys Networks 1G58x-09 - Manual (Page 596)

Process Overview: Routing Protocol Configuration
Configuring RIP
13-2 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
13.1.1 Configuring RIP
Purpose
To enable and configure the Routing Information Protocol (RIP).
RIP Configuration Task List and Commands
Table 13-1 lists the tasks and commands associated with RIP configuration. Commands are
described in the associated section as shown.
NOTE: Enabling RIP with the router rip and network commands is required if you
want to run RIP on the device. All other tasks are optional.
Table 13-1 RIP Configuration Task List and Commands
To do this... Use these commands...
Enable RIP configuration mode and
associate a network. router rip ( Section 13.1.1.1 )
network (RIP) ( Section 13.1.1.2 )
Allow unicast updates by defining a
neighboring router. neighbor (RIP) ( Section 13.1.1.3 )
Configure an administrative distance. distance ( Section 13.1.1.4 )
Apply offsets to RIP routing metrics. ip rip offset ( Section 13.1.1.5 )
Adjust timers. timers ( Section 13.1.1.6 )
Specify a RIP version. ip rip send version ( Section 13.1.1.7 )
ip rip receive version ( Section 13.1.1.8 )