Enterasys Networks 1G58x-09 - Manual (Page 411)

Policy Classification Configuration Command Set
Assigning Classification Rules to Policy Profiles
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 8-19
8.3.2.7 set vlanauthorization
Use this command to enable or disable VLAN tunnel attribute processing during policy
authentication. Disabling this attribute will prevent authenticated VLAN tunnel attributes from
being applied, but will not prevent the port from being authenticated.
set vlanauthorization {enable | disable [port-string]}
Syntax Description
Command Defaults
If port-string is not specified, VLAN authorization will be globally enabled, but
will not be enabled on any ports.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable VLAN authorization globally, and on ports fe.0.1 through 4:
NOTE: The following RADIUS tunnel attributes must be present for proper VLAN
authentication:
• Tunnel-medium-type = 802
• Tunnel-Type = Virtual LANs (VLANs)
• Tunnel-pvt-group-id = VLAN number to authenticate.
enable | disable Enables or disables VLAN tunnel attribute processing.
port-string (Optional) Specifies the port(s) on which VLAN tunnel
attribute processing will be enabled or disabled. VLAN
authorization must be globally enabled, and enabled on
all authentication ports, for policy authentication using a
VLAN tunnel attribute to take effect.
Matrix>set vlanauthorization enable
Matrix>set vlanauthorization enable fe.0.1-4