Enterasys Networks 1G58x-09 - Manual (Page 650)

Process Overview: Routing Protocol Configuration
Configuring OSPF
13-56 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
This example shows how to display information about OSPF border routers. The first line of this
output shows that an intra-area route has been established to destination border router 192.168.22.1
via neighboring router 192.168.11.1 on the VLAN 2 interface in area 0. The OSPF cost of this route
is 64, and it carries an SPF calculation of 10. The destination router is an ABR:
13.1.2.26show ip ospf interface
Use this command to display OSPF interface related information, including network type, priority,
cost, hello interval, and dead interval.
show ip ospf interface [vlan vlan_id]
Syntax Description
Command Type
Router command.
Command Mode
Privileged EXEC: Matrix>Router#
Command Defaults
If vlan_id is not specified, OSPF statistics will be displayed for all VLANs.
Matrix>Router#show ip ospf border-routers
OSPF internal
Codes: i - Intra-area route, I - Inter-area route
i 192.168.22.1
[
64
]
via 192.168.11.1, VLAN2, ABR, Area 0, SPF 10
i 192.168.22.1 [ 64 ] via 192.168.11.1, VLAN2, ABR, Area 4, SPF 10
i 192.168.44.1
[
64
]
via 192.168.33.1, VLAN1, ABR, Area 0, SPF 10
i 192.168.44.1 [ 64 ] via 192.168.33.1, VLAN1, ABR, Area 2, SPF 7
i 192.168.44.2
[
128
]
via 192.168.33.1, VLAN1, ABR, Area 0, SPF 10
i 192.168.44.2
[
128
]
via 192.168.11.1, VLAN2, ABR, Area 0, SPF 10
vlan vlan_id (Optional) Displays OSPF information for a specific VLAN.
This VLAN must be configured for IP routing as described
in
Section 3.3.2 .