Enterasys Networks 1G58x-09 - Manual (Page 318)

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
6-32 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Mode
Read-Write.
Example
This example shows how to allow Spanning Tree edge ports to transmit topology change traps:
6.2.1.35 clear spantree tctrapsuppress
Use this command to clear topology change trap suppression settings.
clear spantree tctrapsuppress
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to clear topology change trap suppression settings:
6.2.1.36 show spantree txholdcount
Use this command to display the maximum BPDU transmission rate.
show spantree txholdcount
Syntax Description
None.
Command Defaults
None.
Matrix>set spantree tctrapsuppress disable
Matrix>clear spantree tctrapsuppress