Enterasys Networks 1G58x-09 - Manual (Page 336)

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Port Parameters
6-50 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Mode
Read-Only.
Example
This example shows how to display the span guard timeout setting:
6.2.2.18 set spantree spanguardtimeout
Use this command to set the amount of time (in seconds) an edge port will remain locked by the
span guard function.
set spantree spanguardtimeout timeout
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the span guard timeout to 600 seconds:
6.2.2.19 clear spantree spanguardtimeout
Use this command to reset the Spanning Tree span guard timeout to the default value of 300
seconds.
clear spantree spanguardtimeout
Matrix>show spantree spanguardtimeout
spanguard timeout is set at 300 seconds.
timeout Specifies a timeout value in seconds. Valid values are 0
(forever) to 65535.
Matrix>set spantree spanguardtimeout 600