Enterasys Networks 1G58x-09 - Manual (Page 369)

VLAN Configuration Command Set
Assigning VLANs According to Classification Rules
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 7-27
Command Defaults
Data masks are required only for classification types requiring a second
data_value. For details, refer to
Table 7-2 .
Command Type
Switch command.
Command Mode
Read-Write.
Command Alternative (v2.05.xx and higher)
set policy classify ( Section 8.3.2.2 )
create | enable |
disable create - Creates a new classification rule that will be
applied to the vlan-id.
enable - If a classification rule is not entered in this
command, this entry enables the global classifier in the
device so that VLAN classification rules may be
implemented.
NOTE: Classification rules are automatically
enabled when created.
disable - If a classification rule is not entered in this
command, this entry disables the global classifier in the
device so that VLAN classification rules may not be
implemented.
If a classification rule is entered in this command, this
entry disables that VLAN classification rule for the
designated VLAN.