Enterasys Networks 1G58x-09 - Manual (Page 381)

VLAN Configuration Command Set
Setting the Host VLAN
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 7-39
Example
This example shows how to display the host VLAN:
7.3.6.2 set port vlan host
Use this command to assign host status to a VLAN. The host VLAN should be a secure VLAN
where only designated users are allowed access. For example, a host VLAN could be specifically
created for device management. This would allow a management station connected to the
management VLAN to manage all ports on the device and make management secure by preventing
management via ports assigned to other VLANs.
set port vlan host vlan-id
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Command Alternative (v2.05.xx and previous)
set host vlan vlan-id
Matrix>show host vlan
Host vlan is 7.
NOTE: Before you can designate a VLAN as the host VLAN, you must create a VLAN
using the set of commands described in
Section 7.3.2 .
vlan-id Specifies the number of the VLAN to set as the host
VLAN.