Enterasys Networks 1G58x-09 - Manual (Page 620)

Process Overview: Routing Protocol Configuration
Configuring OSPF
13-26 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
13.1.2 Configuring OSPF
Purpose
To enable and configure the Open Shortest Path First (OSPF) routing protocol.
OSPF Configuration Task List and Commands
Table 13-2 lists the tasks and commands associated with OSPF configuration. Commands are
described in the associated section as shown.
.
NOTE: Enabling OSPF with the router ospf and network commands are required if
you want to run OSPF on the device. All other tasks are optional.
Table 13-2 OSPF Configuration Task List and Commands
To do this... Use these commands...
Enable OSPF configuration mode,
associate a network and assign a router
ID. router ospf ( Section 13.1.2.1 )
network ( Section 13.1.2.2 )
router id ( Section 13.1.2.3 )
Configure OSPF Interface Parameters.
• Set the cost of sending a packet on
an OSPF interface. ip ospf cost ( Section 13.1.2.4 )
• Set priority to help determine the
OSPF designated router for the
network. ip ospf priority ( Section 13.1.2.5 )
• Adjust timers and message
intervals. timers spf ( Section 13.1.2.6 )
ip ospf retransmit-interval ( Section 13.1.2.7 )
ip ospf transmit-delay ( Section 13.1.2.8 )
ip ospf hello-interval ( Section 13.1.2.9 )
ip ospf dead-interval ( Section 13.1.2.10 )