Enterasys Networks 1G58x-09 - Manual (Page 495)

Logging and Network Management Command Set
Monitoring Switch Network Events and Status
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-25
Syntax Description
Command Defaults
If no parameters are specified, the last command will be repeated.
Command Type
Switch.
Command Mode
Read-Write.
Example
This example shows how to repeat cmd_num 1 (show arp in the history buffer display). It is
repeated once
:
cmd_num (Optional) Specifies the number of the command from
the history display.
iterations (Optional) Specifies the number of times to re-execute
the command. Valid values are 0 to 2147483647.
Entering 0 causes the specified cmd_num to be repeated
endlessly until the user enters Ctrl+C.
Matrix>history
1 show arp
2 history
3 show ip
4 show cdp fe.0.1
5 history
Matrix>repeat 1 1
Matrix>show arp
LINK LEVEL ARP TABLE
destination gateway flags Refcnt Use Interface
--------------------------------------------------------------------------
10.1.0.1 00:00:1d:bc:df:bf 405 1 0 host0
10.1.10.10 00:00:1d:1f:27:26 405 0 11338 host0
--------------------------------------------------------------------------