Enterasys Networks 1G58x-09 - Manual (Page 690)

Security Configuration Command Set
Configuring RADIUS
14-8 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Examples
This example shows how to enable the RADIUS client for authenticating with a RADIUS server 1
at IP address 10.1.6.203, UDP authentication port 1812. As previously noted, the “server secret”
password entered here must match that already configured as the Read-Write (rw) password on the
RADIUS server:
This example shows how to set the RADIUS timeout to 5 seconds:
This example shows how to set RADIUS retries to 10:
14.3.1.3 clear radius
Use this command to reset RADIUS server settings to default values.
clear radius {[last-resort-action [local | remote]] [retries] [server {index | all}]
[timeout]}
Syntax Description
Command Type
Switch command.
Matrix>set radius server 1 10.1.6.203 1812
Server Secret:******
Retype Server Secret:******
Warning: rfc2138 recommends secret minimum length of 16
Matrix>set radius timeout 5
Matrix>set radius retries 10
last-resort-action
local | remote Resets the last resort local and/or remote action to
Challenge.
retries Resets the maximum number of attempts a user can contact
the RADIUS server before timing out to 3.
server index | all Resets a specific or all RADIUS server configurations.
timeout Resets the maximum amount of time to establish contact
with the RADIUS server before timing out to 20 seconds.