2 set flowlimit, Set flowlimit -105, Section 14.3.9.2 – Enterasys Networks 1G58x-09 User Manual
Page 787
Security Configuration Command Set
Configuring Flow Setup Throttling (FST)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
14-105
14.3.9.2 set flowlimit
Use this command to enable or disable flow setup throttling globally or on one or more port(s), or
to re-enable one or more port(s) that were disabled due to flow setup throttling.
set flowlimit {[system | port-string disable | enable] [port-string operational]}
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Flow limit
shutdown
Whether flow limit shut down is enabled or disabled.
Default state of disabled can be changed with the set
flowlimit shutdown command (
Flow limit
notification
interval
Interval in seconds at which an SNMP notification will be
sent when a specified flow limit is reached. This function
can be enabled, and the default interval of 120 can be
changed, with the set flowlimit notification command
(
Flow limit
maximum
flowcount
Number of flows that, if exceeded, will trigger a configured
action. Set using the set flowlimit limit command
(
Flow limit table
Lists flow limits and assigned actions for FST port
classifications.
system |
port-string
disable | enable
Enables or disables FST globally or one specific port(s).
port-string
operational
Re-enables one or more ports disabled by the flow limit
shut down function (as described in
).
Table 14-8
show flowlimit Output Details (Continued)
Output
What It Displays...