Enterasys Networks 1G58x-09 - Manual (Page 55)

Startup and General Configuration Summary
Factory Default Settings
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-7
ARP table No permanent entries configured.
ARP timeout Set to 1200 seconds (20 minutes).
Authentication key
(RIP and OSPF) None configured.
Authentication mode
(RIP and OSPF) None configured.
Dead interval (OSPF) Set to 40 seconds.
Disable triggered
updates (RIP) Triggered updates allowed.
Distribute list (RIP) No filters applied.
DoS prevention Disabled.
DVMRP Disabled. Metric set to 1.
Hello interval (OSPF) Set to 10 seconds for broadcast and point-to-point networks. Set to
30 seconds for non-broadcast and point-to-multipoint networks.
Host name System command prompt set to Matrix>Router.
ICMP Enabled on routing interfaces for both echo-reply and mask-reply
modes.
IP-directed broadcasts Disabled.
IP forward-protocol Enabled with no port specified.
IP interfaces Disabled with no IP addresses specified.
IRDP Disabled on all interfaces. When enabled, maximum advertisement
interval is set to 600 seconds, minimum advertisement interval is set
to 450 seconds, holdtime is set to 1800 seconds, and address
preference is set to 0.
Logging Enabled to send event notification messages to Syslog, buffer,
console, and Telnet, with severity level set to high.
Table 3-2 Default Device Settings for Router Mode Operation (Continued)
Device Feature Default Setting