Enterasys Networks 1G58x-09 - Manual (Page 625)

Process Overview: Routing Protocol Configuration
Configuring OSPF
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 13-31
13.1.2.4 ip ospf cost
Use this command to set the cost of sending a packet on an interface. Each router interface that
participates in OSPF routing is assigned a default cost. This command overwrites the default of 10.
ip ospf cost cost
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command resets the OSPF cost to the default of 10:
no ip ospf cost
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan <vlan_id>))#
Command Defaults
None.
Example
This example shows how to set the OSPF cost to 20 for VLAN 1:
13.1.2.5 ip ospf priority
Use this command to set the OSPF priority value for router interfaces. The priority value is
communicated between routers by means of hello messages and influences the election of a
designated router.
ip ospf priority number
cost Specifies the cost of sending a packet. Valid values range
from 1 to 65535.
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip ospf cost 20